![]() ![]() Specifies the repetition rate of the keyboard when a key is pressed. The settings can also be specified via the operating system. If Disabled, the values are set to 6 characters per second, with a keyboard delay of 250 ms. This parameter is used to specify whether the options Keyboard Typematic Speed, Delay Before Keys Repeat, Typematic Rate or Typematic Delay are available. DOS will anchor itself there, if DOS=High is inserted in Config.sys. The first 64 K Block above 1 MB can be accessed in standard mode via address line A20. This option may speed up older computers. With the Normal setting it is accessed via the keyboard controller. This should be set to Fast, in order to activate access through the chipset. Gate A20 Optionĭefines how the memory above 1MB is accessed. "First Boot Device", "Second Boot Device" or "Third Boot Device". The Enabled setting enables the BIOS to try all three types, i.e. This option offers two choices: Enabled or Disabled. This setting is used for booting, if the first and second boot device are not available. This setting is used for booting, if the first boot device is not available. Here you can specify which drive should boot first. Here you can disable the internal CPU cache. ↑ ↓ → ← :Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:Helpį5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults The hard disk data (size, number of cylinders, heads, sectors, pre-compensation and home position of the heads when the disk is switched off) are displayed automatically for the connected hard disk. This menu is used for setting the data of the first hard disk connected to the IDE bus as master. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |